X-Type Bottom Bracket Outboard Cup Tool

Removes and installs bearing cups for outboard type bottom brackets like the Shimano Hollowtech II, Race Face X-Type, FSA, Truvativ.

Designed not to mark the cups or cause burring, these will keep your cups looking like new.

Uses a standard 1/2 inch socket drive. Includes crank arm cap tensioner for Hollowtech II systems. Replaces tools TL FC32 and TL FC16

Campagnolo Ultra Torque Bottom Bracket Cup Tool

Designed to allow the removal and installation of Campagnolo Ultra Torque bottom bracket cups with marking them. Fit a standard 1/2 inch socket drivers allowing for correct torque.

Enduro Blind Hole Bearing Puller

Use to remove cartridge bearings from seats. Includes collets to remove bearings with inside diamter 8mm-32mm.

Can also be used to remove remaining outer race from disintegrated bearings.

Bottom Bracket Outboard BEARING PULLER/PRESS

Removes and installs bearings in outboard type bottom brackets like the Shimano Hollowtech II, Race Face X-Type FSA, Truvativ.

the Enduro Hub Bearing Press is designed too allow the user to easily and safely press any combination of bearings into hubs. Bearing drivers are provided for;

• 608
• 6000
• 6001
• 6802
• 6803
• 6804
• 6805
• 6901
• 6902
• 6903
• R6
• R8
• MR 1526

Shock eye bushing tool for mountain bike rear shocks.
With the right drivers you can replace the standard bushings on most model shocks as well as Enduro Needle bearings for 1/2 inch shock eyes.

With a 6mm allen key you can replace shock eye bushings quickly. On many bikes you can change the bushing without removing the shock from the bike.

Includes: 1/2 inch bushing driver for Fox Rockshox newer X-Fusion etc. Other drivers are available see Shock eye bushing hardware and tools

Suitable for all bearings this is the grease used in our ceramic hybrids
Made by Kyodo Yushi this grease is light but stays in place and retains state without drying.

Dimensions: 10-25 mm IDTypical Application:

Allows easy removal installation and torquing of the Lefty Hub cap. This cap is required to be removed to replace the hub bearings.

aka DU Bushings. 12mm for Manitou, Rock Shox 05 on
X-Fusion -2007

aka DU Bush In 1/2 inch for Fox, 5th Element coil, Romic etc
X-Fusion 2008-